Documentation
Getting Started
Step 2b: UNO Q & ESP32 over USB

Step 2b: UNO Q and ESP32: install over USB

The Arduino UNO Q and ESP32 boards don't need a memory card. The Palpable app installs Palpable straight onto the board through a USB cable.


Use Chrome, Edge, Arc or Dia

Installing over USB works only in these browsers. Safari and Firefox can't talk to a board over USB. If you open setup in another browser, the app tells you and gives you a link to open in the right one.

Plug the board into your computer

Use a USB cable that carries data (some charging-only cables don't). The cable also powers the board.

Start the install

The app tells you what will happen. Installing Palpable replaces the system that is on the board now (for example Arduino's own system on the UNO Q). When you're ready, start the install and choose your board in the list your browser shows.

For an ESP32 board, the app finds out which chip it has while it installs, and may ask you which board it is.

Wait for it to finish

The app shows how long it takes and its progress. Keep the board plugged in and the tab open until the app says Palpable has been installed.

Want Arduino's system back on your UNO Q? Open the board in the app, go to Manage, and choose Return this board to Arduino. The app walks you through Arduino's own flashing tool.

💡

On an ESP32, scripts need the connection for now. On a Raspberry Pi or the UNO Q, your project's scripts run on the board and keep running if the internet drops. ESP32 boards run them through the cloud today, so they need Wi-Fi to work.

If you see something else

  • The install stops partway or can't reach the board, and the app's own instructions didn't fix it: what to do
  • The install finished but the board never comes online: what to do

Next: Step 3: Connect modules →