Project Ideas
Every Palpable project starts the same way: you tell PAL what you want, PAL writes the project's script, and you press Run.
Here are some ideas to get you started. For each one, we show what to say to PAL and which modules you need.
Temperature alert
What it does: Sends a notification to your phone when the temperature gets too high.
Tell PAL:
"When the temperature goes above 30 degrees, send me a notification. Not more than once every 5 minutes."
Modules needed: Modulino Thermo or BME280
Motion-activated lights
What it does: Turns on the LEDs when something comes close, then turns them off after 10 seconds.
Tell PAL:
"When something gets within 50 cm of the distance sensor, turn the pixels warm white for 10 seconds."
Modules needed: Modulino Distance + Modulino Pixels
Button plays a sound
What it does: Press a button, hear a beep. Simple and satisfying.
Tell PAL:
"When I press button A, play a short beep."
Modules needed: Modulino Buttons + Modulino Buzzer
The Modulino Buttons module has 3 buttons (A, B, C). Give each one its own job: different sounds, different actions, whatever you want.
Knob controls a value
What it does: Turn the knob to change a value, like brightness, a servo angle or a speed.
Tell PAL:
"When I turn the knob, set the brightness of the pixels from off to full."
Modules needed: Modulino Knob (+ whatever the knob should control)
Morning message
What it does: Sends a "Good morning" notification every weekday at 8 AM.
Tell PAL:
"Send me a 'Good morning' notification every weekday at 8 AM."
Modules needed: None.
Smart watering
What it does: Checks the soil every morning. If it's dry, runs a pump for 60 seconds and tells you. If it's moist enough, does nothing.
Tell PAL:
"Every morning at 7 AM, check the soil moisture. If it's below 30%, turn on the relay for 60 seconds and notify me."
Modules needed: A soil moisture sensor + Qwiic Relay (connected to a pump)
Air quality monitor
What it does: Watches CO2 and air quality, tells you when the air gets stale, and shows the readings on a display.
Tell PAL:
"If CO2 goes above 1000 ppm, send me a notification. Also show the current CO2 and air quality on my display."
Modules needed: SCD41 (CO2) + SGP40 (air quality) + a display such as the SSD1306 OLED
Tips
Say how often
A notification for "above 30°C" would fire again and again while it stays hot. Tell PAL how often is enough: "at most once every 10 minutes."
Projects can remember things
A project can keep values between moments, like a counter that goes up each time a button is pressed, or a "day" and "night" mode. Just describe it to PAL.
Where projects run
On a Raspberry Pi or the UNO Q, a project's script runs on the board and keeps working if the internet goes down. On an ESP32 board it needs the connection for now.
Messages with live values
Notifications can include readings. Just ask:
"Send a notification that says 'Temperature is currently X degrees'."